Overview
The G2 Axle and Gear 25-2060 is a minor ring and pinion installation kit for the GM 218mm. Camaro rear axle. It covers the install parts for a rear differential gear change on a GM 218mm axle where the bearings do not need replacing.
The kit bundles a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound into one box for a rear gear change.
Key features
- GM 218mm axle installation kit named for the Camaro
- Rear axle location
- Minor kit for installs that keep the bearings
- Shim kit for gear setup
- Pinion nut, crush sleeve and pinion seal included
- Ring gear bolts, sealer, Loctite and marking compound
Break-in after a gear swap
A new ring and pinion needs a short period of careful driving to seat the teeth. Light throttle and moderate speeds help the contact surfaces wear in evenly, and hard loads early on can mark the new teeth. Keep an eye on the gear oil level during the first drives, since a new setup can settle slightly.
Pinion depth and backlash are set with shims before the install is finished. The crush sleeve sets pinion bearing preload and is replaced each time. Loctite on the ring gear bolts keeps them from loosening under load, so clean the threads and tighten them in a crisscross pattern.
- Drive gently during the first stretch
- Check the gear oil level after early drives
- Clean threads before applying thread locker
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2060 |
| UPC | 631410111170 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | GM |
| Axle type | GM 218mm. |
| Axle location | Rear |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
The 25-2060 is a Universal Fit kit for the GM 218mm rear axle used under the Camaro, so it is selected by axle size rather than by a Camaro model year.
The 25-2060 does not cover front axles or other GM axle sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and backlash on a GM 218mm rear end are set with shims, and the marking compound confirms the pattern. G2 includes no gears in the 25-2060, so plan for them separately and for a professional install. A careful break-in follows new gears. The crush sleeve is a single-use part that sets pinion bearing preload, and Loctite holds the ring gear bolts so they do not back out under load.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: the ring and pinion and bearings.








