Overview
The G2 Axle and Gear 25-2055 is a minor ring and pinion installation kit for the front axle of the Toyota Tacoma, listed under a Toyota 7.5 Inch axle name. It gives an installer the setup parts for a front differential gear swap without replacing the bearings.
G2 says its minor kits are for a newer vehicle that has no need for new bearings, and that they hold hard-to-find parts. The 25-2055 contains a shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Key features
- Front axle installation kit named for the Toyota Tacoma
- Toyota 7.5 Inch axle
- Minor kit that keeps the existing bearings
- Shim kit for pinion depth and backlash
- Pinion nut, crush sleeve and pinion seal included
- Bolts, silicone sealer, Loctite and marking compound
Shim selection on a front differential
A front differential shares the same basic setup as a rear one, but the work is done in a tighter space under the vehicle. Shim selection sets pinion depth first, then the carrier position and backlash. Each change is small, and the marking compound pattern is the check that confirms the setup before the cover is closed.
Gear oil and seals matter on a front axle too. The pinion seal keeps oil inside the housing, and a worn seal can leak once the pinion has been moved. Clean the housing surfaces, inspect the carrier bores and confirm the bearings turn smoothly before the work begins.
- Set pinion depth before carrier position
- Clean mating surfaces before sealing
- Inspect the carrier bores for wear
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2055 |
| UPC | 631410108033 |
| Product type | Minor ring and pinion installation kit |
| Kit class | Minor kit |
| Axle manufacturer | Toyota |
| Axle type | Toyota Tacoma |
| Axle location | Front |
| Kit contents | Shim kit, replacement pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite, gear marking compound |
Vehicle fitment
The 25-2055 is a Universal Fit kit for the Toyota Tacoma front axle, so it is chosen by the 7.5 inch axle size rather than by a year range.
The 25-2055 is a front axle kit only and does not cover the rear axle or other Toyota models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear setup on a Tacoma front differential involves shim selection and a check of the contact pattern with the marking compound. No gears are in the kit, so a trained installer should handle the swap. Fresh gear oil is needed once the housing is closed. The pinion seal keeps gear oil inside the housing, and the crush sleeve is a single-use part that sets pinion bearing preload, which is why both arrive as fresh parts.
What’s included
- Shim kit
- Replacement pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite
- Gear marking compound
Not included: the ring and pinion gear set and bearings.







