Overview
The G2 Axle and Gear 35-2026 is a master ring and pinion install kit for the Chrysler AAM 9.25-inch front axle. It is made for 2003-2013 2500 and 3500 applications. It collects the pinion nut, seals, bearings, shims, crush sleeve and assembly compounds used in a ring and pinion replacement on that axle.
Key features
- Master kit with pinion nut and pinion seal
- Timken outer and inner pinion bearing and race sets
- Crush sleeve plus pinion and carrier shims
- Carrier bearings and races with ring gear bolts
Heavy-duty front axle setup
A front axle on a heavy-duty 2500 or 3500 truck carries more load and steering force than many lighter axles, so pinion depth and carrier preload should be checked with care. The 9.25-inch housing needs a clean, square carrier bore before the new bearings are installed. Drive shaft angles and the front u-joints can influence how the gear set wears, so inspect them during the job.
Bearings are usually the first part to fail when preload is off, and a whining front end is the usual sign. Keep the old crush sleeve out of the rebuild and install a new one. Replace the pinion seal and check the axle breather before refilling with fresh lubricant.
- Inspect front u-joints and drive shaft angles
- Check the carrier bore is clean and square
- Replace the pinion seal during the rebuild
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2026 |
| UPC | 631410126464 |
| Axle type | Chrysler AAM 9.25-inch front |
| Pinion bearings | Timken outer and inner |
Vehicle fitment
Fit is for the Chrysler AAM 9.25-inch front axle on 2003-2013 2500 and 3500 vehicles.
Front axles outside the 2500 and 3500 range fall outside this fit, so check your year and model first.
Installation notes
Pinion depth and carrier preload are set with the included shims and crush sleeve. That job calls for measuring tools and gear-setting experience, so professional setup is the practical route on a 9.25-inch front axle.
What’s included
- Pinion nut
- Pinion seal
- Timken outer and inner pinion bearings and races
- Crush sleeve
- Pinion shims and carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
Not included: the ring gear and pinion pair, which must be obtained as a matched set.







