Overview
The G2 Axle and Gear 35-2041 is a master ring and pinion installation kit with bearings for the Toyota 8-inch (4 cylinder) axle, for front and rear third members.
The 35-2041 includes the parts needed to install a ring and pinion, with pinion and carrier bearings along with the shims, nut, seal and compounds. Some of its parts are hard-to-find items that auto parts stores rarely stock. It is for use in 4 cylinder Toyota front and rear third members. The ring and pinion gear set is not included.
Key features
- Master kit with bearings for the Toyota 8-inch (4 cylinder) axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 4 cylinder Toyota front and rear third members
Measuring and setup
Ring and pinion work is mostly measurement. Pinion depth, carrier bearing preload and backlash all interact, so a shim change on one side usually shifts the other. Check each setting before the cover goes back on, and keep a written record of shim stack thickness so the work can be repeated or corrected later.
Front and rear third members see different loads, but both rely on the same pinion bearings and carrier preload to keep the gears in position. After reassembly, inspect the pinion seal and carrier bearings for seepage or rough rotation, and watch the first short drives for noise that changes with speed or load.
- Replace the pinion nut and crush sleeve rather than reusing them
- Clean the carrier and pinion mating surfaces before measuring
- Recheck the ring gear bolts after the first short drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2041 |
| UPC | 631410095890 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | Toyota 8-inch (4 cylinder) |
| Axle location | Front and rear |
| Popular axle manufacturer | Toyota |
| Kit type | Master kit with bearings |
| Listing condition | For use in 4 cylinder Toyota front and rear third members |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2041 is identified by axle rather than by vehicle: it is made for the Toyota 8-inch (4 cylinder) axle in the front and rear positions. Confirm fit for your vehicle’s year, model and trim before ordering.
The 35-2041 is made only for the Toyota 8-inch (4 cylinder) axle and is not designed for other axle designs or sizes. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A master kit such as the 35-2041 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2041 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2041: ring and pinion gear set.













