Overview
The G2 Axle and Gear 2-2090-410 is a ring and pinion gear set for a GM 12 Bolt 9.5 inch rear axle, with a 4.10 gear ratio. G2 designs its performance ring and pinion sets for oversized tires and high-performance engines.
The sets use current gear technology and materials to deliver quiet, strong performance. The gears are made for the rear axle, and the ratio is 4.10.
Key features
- Fits the GM 12 Bolt 9.5 inch rear axle
- 4.10 gear ratio
- Designed for oversized tires and high-performance engines.
- Built with current gear technology and materials
Pattern and backlash basics
The tooth contact pattern shows how the ring and pinion mesh under load, and backlash is the small gap between the teeth. Both settings change noise, wear and gear life, which is why a new set is often checked by a gear installer before it is driven. Small changes in pinion depth can alter the pattern noticeably.
On an older GM 12 Bolt, the carrier bearings, pinion seal and axle bearings are often part of the job as well. Worn bearings can change the setup, so inspect them while the axle is apart. Keep the new ring and pinion with its matched pinion and use the same set throughout.
- Ask for a contact pattern check before driving
- Replace the pinion seal during the gear change
- Check the carrier bearings for play
- Keep the gear set matched and labeled
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2090-410 |
| Axle location | Rear |
| Axle type | GM 12 Bolt 9.5 inch |
| Axle manufacturer | GM |
| Gear ratio | 4.10 |
| Fit | Labeled universal fit |
Vehicle fitment
The set is made for the GM 12 Bolt 9.5 inch rear axle. Compare the axle housing and ring gear with your current setup before ordering, since a ring and pinion must match the housing and gear design.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion sets need correct tooth contact pattern and backlash setup, which is usually done by an experienced gear installer. A new gear set also needs a break-in period, so ask the installer how to run the gears in.

















