Overview
The G2 Axle and Gear 25-2096A is a minor ring and pinion install kit for the GM 9.25 IFS axle. IFS means independent front suspension, so this kit is aimed at the front differential of that setup.
Gear sets are not included, so the 9.25 IFS ring and pinion must be supplied separately from this kit.
Setting up the front carrier
On an independent front axle, the ring and pinion sits inside a carrier that moves with the suspension, so setup depends on keeping pinion angle and gear mesh within tight limits. Front differentials see both drive and steering loads, which makes a correct break-in and fresh fluid more important than on a solid axle.
Gear mesh and carrier preload are typically set with a shim pack and a crush sleeve, and both should be checked after the first few drives. Worn carrier bearings or a loose pinion nut can cause noise that resembles gear damage, so inspect those parts whenever a whine or clunk changes with load.
- Check gear mesh after the first few drives
- Change fluid after a new gear set is broken in
- Inspect carrier bearings when noise changes with load
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2096A |
| UPC | 631410113198 |
| Axle | GM 9.25 IFS |
| Kit type | Minor ring and pinion install kit |
Vehicle fitment
It is for the GM 9.25 IFS axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Gear mesh and carrier preload are set during this kind of job, so professional setup is the usual route, followed by a break-in period.
What’s included
Ring gear bolts, carrier shims, pinion shims, crush sleeve, pinion seal, pinion nut, thread locking compound, gear marking compound and silicone sealer.
Not included: the gear set itself, sourced separately.







