Overview
The G2 Axle and Gear 2-2010-410 is a 4.10 ratio ring and pinion for the GM 14 bolt 9.5 inch rear axle. It is made for the rear location and works with all ratio carriers, so the carrier does not limit the choice of this gear set.
Performance sets from G2 are designed for oversized tires and high performance engines. This 9.5 inch 4.10 set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces, built to O.E. specifications.
Key features
- 4.10 rear ring and pinion
- GM 14 bolt 9.5 inch axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Rear axle gear basics
The rear ring and pinion sets the final drive ratio for the wheels on a solid rear axle. On a 14 bolt GM housing, the ring gear bolts to the differential case, and the pinion turns it from the driveshaft. Gear ratio is only part of the picture, since tire diameter, transmission gearing and engine output all change how a 4.10 set feels, so it helps to think about the whole driveline when choosing.
Gears and bearings wear as a set. When new gears are installed, the carrier bearings, pinion bearings and pinion seal are often renewed too, because preload on old bearings can settle and change the mesh. Watch for whine under load or coast, metal in the differential fluid, or a clunk on tip-in as signs the existing gears are worn. Fresh fluid after break-in helps keep the new surfaces clean.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2010-410 |
| UPC | 631410093384 |
| Gear ratio | 4.10 |
| Axle location | Rear |
| Axle type | GM 14 bolt 9.5 inch |
| Popular axle manufacturer | GM |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the GM 14 bolt 9.5 inch rear axle at a 4.10 ratio. Match the housing to the 9.5 inch GM 14 bolt size before ordering.
Only the GM 14 bolt 9.5 inch is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Have a driveline shop set pinion depth, backlash and bearing preload on the 9.5 inch 4.10 gears, then run them through a break-in period.
What’s included
A matched ring and pinion for the GM 14 bolt 9.5 inch rear axle.














