Overview
The G2 Axle and Gear 2-2138-513 is a 5.13 ratio ring and pinion for a Nissan rear axle. The pinion turns 5.13 times for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels and favors low-speed pulling.
Model, years and axle size are needed to match this set to a vehicle. Confirm the Nissan axle and ring gear size on your vehicle before buying.
Key features
- 5.13 gear ratio
- Rear axle location
- Built for a Nissan rear axle application.
Matching a Nissan ring gear
A 5.13 ratio is a steep setting, so the pinion turns more times per wheel turn than a common highway ratio. That helps with trailer work, rock crawling and hill climbs, but the engine runs faster at cruising speed. Think about how the vehicle is used before making a change of this size.
Matching the ring gear and pinion depends on the axle housing and carrier. Count the teeth on the ring gear and compare them with the new set, and check the carrier bearing preload before the gears go in. Gear sets are normally replaced in pairs, with the carrier bearings and seals checked during the job.
- Count ring gear teeth before ordering
- Inspect carrier bearings for play
- Replace pinion seal during installation
- Refill with fresh gear oil after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2138-513 |
| UPC | 631410132724 |
| Application | Nissan |
| Axle location | Rear |
| Gear ratio | 5.13 |
Vehicle fitment
This set is for a Nissan rear 5.13 axle. Check the model, years and ring gear size on your vehicle before ordering, since those details decide the match.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear mesh and carrier preload need measuring tools, so a gear shop is the usual installer. Break in the new gears before heavy loads.
What’s included
One 5.13 ring and pinion set, part number 2-2138-513.
Not included: Carrier bearings and shims are not part of this set.







