Overview
The G2 Axle and Gear 2-2011-457 is a 4.57 ratio ring and pinion for the rear Ford 9 inch axle. It is a universal fit by axle type, so the gears are matched to the axle size rather than to a particular model.
G2 says its performance ring and pinion sets are built for oversized tires and high performance engines, using the latest technology and materials. At 4.57, this set multiplies torque at the wheels more than a 4.30 ratio.
Key features
- 4.57 ratio rear ring and pinion
- Ford 9 inch rear axle type
- Suited to oversized tires and high performance engines.
- Produced with the latest technology and materials.
Matching the ratio to your driving
A 4.57 ratio suits drivers who spend time at low speed, on steep grades or with heavy loads. Because the pinion turns more times per ring gear revolution, the engine can pull harder off the line, though highway cruising will run at higher rpm.
Tire size is one of the biggest factors in how the final drive feels. Taller tires lower the effective ratio, so a 4.57 set paired with large tires can feel close to a stock gear on the road. Gearing decisions are easier when they are made with the tire size and transmission in mind.
When the gears are replaced, consider the bearings, pinion crush sleeve and carrier shims as part of the job. Set the gear pattern and backlash carefully, then run the axle gently through its first trips so the new teeth can settle.
- Consider tire diameter before choosing a ratio
- Replace pinion crush sleeves with the gears
- Recheck backlash after the first trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-457 |
| UPC | 631410105445 |
| Gear ratio | 4.57 |
| Axle location | Rear |
| Axle type | Ford 9 inch |
| Popular axle manufacturer | Ford |
Vehicle fitment
It fits the Ford 9 inch rear axle at a 4.57 ratio. Confirm the housing size for your vehicle before ordering.
Only the Ford 9 inch is named for this 4.57 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 4.57 gears before the axle goes through its break-in period.
What’s included
A 4.57 ring and pinion set for the Ford 9 inch.
















