Overview
This is a 4.88 ratio front reverse ring and pinion for the Ford 8.8 inch front axle. It works with all ratio carriers, so the carrier ratio does not limit which 4.88 set you use.
The front reverse layout is the gear arrangement this set is built for. The gears are made for oversized tires and high performance engines, from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- Front reverse ring and pinion for the 8.8 inch front axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Fit and setup checks
A 4.88 ratio front reverse set changes how the front axle turns under load, and it is most often used with oversized tires or high torque engines. Before choosing it, measure the tire diameter and confirm the front axle housing matches the Ford 8.8 inch size. A mismatch here is harder to fix after the gears are installed.
Front reverse gear sets need careful setup. The pinion depth, backlash, and bearing preload are set together, and the carrier should be checked after the first drives. Many installers also replace the pinion bearings and seals while the carrier is open, which keeps the new gears running quietly.
- Measure the front axle housing before ordering
- Set backlash by contact pattern, not by feel
- Plan a break-in period on the new gears
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2088-488 |
| UPC | 631410094763 |
| Gear ratio | 4.88 |
| Axle location | Front |
| Axle type | Ford 8.8 inch |
| Popular axle manufacturer | Ford |
| Carrier requirement | All ratio carriers |
| Configuration | Front reverse |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
This set is for the Ford 8.8 inch front axle at a 4.88 ratio. Confirm the housing size and front axle type for your vehicle before ordering.
It is not made for the Ford 8.8 inch rear axle or for other axle sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Front reverse gears need pinion depth, backlash and bearing preload set by a driveline shop, followed by a break-in period on the 4.88 ratio.
What’s included
A matched front reverse ring and pinion for the Ford 8.8 inch front axle.
















