Overview
The G2 Axle and Gear ring and pinion set 2-2029-488 is a 4.88 ratio gear set for the Chrysler 8.25 in. axle, with an OE designation. Its UPC is 631410113273. Verify the housing against your axle before fitting it.
Setting up a gear set
A ring and pinion set is the most important part of the final drive gearing, and its performance depends on how it is set up in the carrier. Contact pattern and backlash are checked after assembly, and small adjustments to shims or preload can change both. Good setup reduces noise and early wear on the gears and bearings.
Gear sets are usually matched as a pair, so the ring and pinion should be replaced together rather than mixed with used parts. Keep the set’s markings with the matching pieces during assembly, and have the carrier checked by a qualified gear shop when the first drive is complete.
- Check contact pattern before final assembly
- Measure backlash at the specified points
- Keep the ring and pinion as a matched pair
- Recheck fasteners after the first break-in drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2029-488 |
| UPC | 631410113273 |
| Axle | Chrysler 8.25 in. |
| Ratio | 4.88 |
| Designation | OE |
Vehicle fitment
It is for the Chrysler 8.25 in. axle. Confirm fit for your housing, year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear sets like this need professional setup, with contact pattern and backlash checked, followed by a break-in period. Follow the break-in steps from your service procedure.
What’s included
The package is a single ring and pinion set.
Not included: carrier bearings, shims and the pinion nut. Obtain these separately and check them against your installation before starting.









