Overview
The G2 Axle and Gear 95-2021-006 is a rear replacement axle shaft for the GM 10 bolt 8.5 inch axle in 1988–1999 GM 1500 two-wheel-drive trucks with independent front suspension. It has 30 splines and uses 14mm press-fit wheel studs.
It is forged from high grade alloy steel and heat treated, and it can be installed on the driver or passenger side of the rear axle.
The 95-2021-006 is the two-wheel-drive version for the GM 10 bolt 8.5 inch rear axle. It has 30 splines and 14mm press-fit studs, and it fits either side. Its steel is forged and heat treated.
Key features
- 30 splines
- 14mm press-fit wheel studs
- Either driver or passenger side
- 2WD IFS trucks
- GM 10 bolt 8.5 inch rear axle
- Wheel studs not included
Front suspension and drivetrain
Independent front suspension changes how the rear axle sits and how the drivetrain loads it. On an IFS truck the front end has its own control arms and joints, so a rear shaft replacement does not involve those parts, but the rear suspension and wheel alignment should still be checked after work. A bent control arm or worn bushing can change the way the rear shaft sees load.
Because the 14mm studs are pressed into the flange, press the new studs fully home and check each one for straightness. Use a clean hub face and avoid over-tightening the lug nuts on a press-fit stud. Inspect the rear brake lines and drum or rotor for damage while the wheel is off, and recheck torque on the wheel nuts after the first short drive.
- Press new 14mm studs fully home
- Check each stud for straightness
- Inspect rear brake lines while the wheel is off
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2021-006 |
| UPC | 631410106060 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 8.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 30 |
| Press-fit wheel stud size | 14mm |
| Wheel studs | Not included |
| Stated application | 1988-1999 GM 1500 2WD IFS |
Vehicle fitment
It fits the 1988–1999 Chevrolet C1500 and the 1988–1999 GMC C1500.
It is for two-wheel-drive C1500 trucks, so four-wheel-drive K1500 trucks are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
- Supply 14mm studs, as none are included.
- Confirm that your truck is two-wheel drive before installing.
What’s included
One rear axle shaft that fits either side (95-2021-006).
Not included: 14mm wheel studs for the 95-2021-006.








