Overview
The G2 Axle and Gear 97-2031-005 is a Dana 30 chromoly inner axle shaft for the passenger side, with 30 splines and a 32.312 inch overall length. It fits 1987-2006 Jeep Cherokee (XJ), Wrangler (YJ) and Wrangler (TJ) models with a 5-760X U-joint.
The shaft is forged alloy steel and heat treated to exceed OEM specifications. The 97-2031-005 has 30 splines, so the differential or carrier must use the same count. An inner axle shaft runs from the differential through the axle tube to the U-joint, so the two sides of a front axle differ in length.
Key features
- Chromoly inner axle shaft for the Dana 30 front axle
- Passenger side, 30 spline, 32.312 inch overall length
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- Fits Jeep XJ, YJ and TJ models from 1987 to 2006
Choosing and measuring the shaft
Before buying a replacement inner, compare its spline count, side and overall length with the shaft coming out. A passenger inner is long, so a shaft that is close in length but not identical can still bind or fail to seat. Match the carrier spline count before anything else.
Larger tires put more load on the axle, which makes the U-joint and the shaft more likely to wear. Upgrades that are often done together include a matched carrier, new U-joints and fresh axle seals. Check the joints for play and dry grease when the front end is serviced.
Chromoly shafts are strong, but no shaft is immune to fatigue. Look for cracks near the spline ends and inspect the clip grooves when reinstalling. A slightly bent shaft shows up as vibration, so replace it rather than straightening it.
Specifications
The 97-2031-005 is a chromoly inner axle shaft for the Dana 30 front axle, with 30 splines and an overall length of 32.312 inches.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2031-005 |
| UPC | 631410097023 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 30 front (Dana 30 Reverse and Dana 30 TJ) |
| Axle shaft location | Passenger side inner |
| Spline | 30 spline |
| Overall length | 32.312 inches |
| U-joint | Accepts 5-760X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 87-06 Jeep XJ/YJ/TJ with 5-760X U-joint |
Vehicle fitment
It fits 87-06 Jeep XJ, YJ and TJ models with a 5-760X U-joint. By chassis code, that covers the 1987-2001 Cherokee (XJ), 1987-1995 Wrangler (YJ) and 1997-2006 Wrangler (TJ).
Application: 87-06 Jeep XJ, YJ and TJ with a 5-760X U-joint.
Before ordering the 97-2031-005, compare its spline count, side and overall length with the shaft being replaced.
It does not fit the Jeep LJ, JK or JL, or any Jeep with a Dana 44 front axle. Confirm the year, model and trim against your vehicle before ordering.
Installation notes
This is the long passenger side inner shaft with 30 splines, so the matching differential or carrier must also be 30 spline. The shaft accepts a 5-760X U-joint and full circle clips.






