Overview
The G2 Axle and Gear 95-2012-004 is a Ford 9.75 inch rear driver side axle shaft with 34 splines and a 5 on 135mm bolt pattern for the 1999–2002 Ford F150, Navigator and Expedition. G2 pairs this driver side shaft with 14mm press fit wheel studs, not included, and says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications.
This driver side shaft has 34 splines, a 5 on 135mm bolt pattern and 14mm press fit wheel studs, which are not included. Its year coverage shows 1999 to 2002 in one place and 1997 to 1999 in another, so 1999 is the only year common to both. Owners of 2000 through 2002 trucks should confirm fit before ordering and check stud size against the hub. The passenger side shaft is 95-2012-003.
Key features
- Driver side rear axle shaft for the Ford 9.75 inch axle
- 34 splines
- 5 on 135mm bolt pattern
- 14mm press fit wheel studs
- Forged from high grade alloy steel.
- Heat treated to exceed OEM specifications.
Driver side fitting checks
Confirm the driver side hub flange has clean stud holes and no cracks before the shaft is fitted. A damaged flange can make the wheel run out of true and wear the bearing early. Measure the splines on the old shaft against the new one if the axle has been modified.
Look over the brake parts and axle seal while the driver side is apart. Grease on the brake lining or a seal that weeps suggests the seal should be replaced at the same time. Clean any old sealant from the housing face.
Work carefully when fitting the driver side shaft into the housing so the splines do not scrape the seal lip. Turn the shaft slowly until it seats, then install the retaining hardware and check it again after a short drive.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2012-004 |
| UPC | 631410105902 |
| Axle manufacturer | Ford |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | Ford 9.75 Inches |
| Position | Rear |
| Spline count | 34 Splines |
| Bolt pattern | 5 on 135mm |
| Wheel stud size | 14mm press fit |
| Material | High grade alloy steel, forged |
| Applications noted | 1999-2002 F150/Navigator/Expedition |
Vehicle fitment
Fitment for the Expedition, F-150 and Navigator is shown by model year below.
- 1997–1999 Ford Expedition (Eddie Bauer, XLT)
- 1997–1999 Ford F-150 (Base, Lariat, XL, XLT)
- 1998–1999 Lincoln Navigator (Base)
Expedition and F-150 coverage runs 1997–1999, and Navigator coverage runs 1998–1999. Check fit before ordering a 2000 to 2002 truck.
What’s included
One rear axle shaft.
Not included: wheel studs.








