Overview
The G2 Axle and Gear 97-2032-003 is a chromoly passenger-side front inner axle shaft for the Dana 30 in the 1972–1981 Jeep CJ5, CJ6, CJ7 and 1981 Scrambler. It has 27 splines and accepts a 5-760X U-joint.
The 97-2032-003 is machined to accept full circle clips. The forging is high-grade alloy steel, heat treated past OEM specifications.
The 97-2032-003 is the passenger-side partner to a driver-side inner shaft, with 27 splines and chromoly construction for the standard Dana 30. It accepts a 5-760X U-joint and full circle clips. G2 Axle and Gear says its shafts are forged from high grade alloy steel and heat treated beyond OEM specifications.
Key features
- Chromoly inner axle shaft for the Dana 30
- 27 splines
- Accepts a 5-760X U-joint
- Machined for full circle clips
- Passenger-side inner shaft
- Front axle
Working on both sides
Front axles on these Jeeps use separate passenger-side and driver-side inner shafts. Replacing only one side can leave the two halves of the axle with different wear, so many rebuilds swap both at once when one has failed. Keep the shafts paired with their own side while the parts are laid out.
Before installing, clean the passenger-side axle tube and check the seal where the shaft enters the differential. A leaking seal will push lubricant onto the new shaft and clips. Confirm the clip groove seats properly before pushing the shaft home, and recheck the U-joint angle after the first drive.
- Clean the axle tube bore before fitting
- Replace the axle seal while the shaft is out
- Keep driver and passenger parts separate until installed
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-003 |
| UPC | 631410097054 |
| Product type | Replacement axle shaft |
| Axle type | Dana 30 Standard |
| Axle location | Front |
| Shaft position | Passenger Side Inner |
| Spline count | 27 |
| Material | Chromoly |
| U-joint | 5-760X |
| Axle end | Machined for full circle clips |
| Stated application | 72-81 Jeep CJ |
Vehicle fitment
Fitment covers the 1972–1981 Jeep CJ5, the 1972–1975 Jeep CJ6, the 1976–1981 Jeep CJ7 and the 1981 Jeep Scrambler.
The list stops at 1981 and the CJ6 appears through 1975, so a later CJ is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Check the U-joint is the 5-760X type before fitting the 97-2032-003.
- The 27-spline shaft has to match your Dana 30 gears.
What’s included
One passenger-side inner axle shaft (97-2032-003).
Not included: the outer shaft, U-joint and clips for the 97-2032-003.





