Overview
The G2 Axle and Gear 98-2034-002 is a Dana 60 front chromoly axle kit with 35 splines for 1975–1993 Dodge W300 and W350 trucks equipped with the Dana 60 front axle.
Dodge W-series owners who break front shafts under big tires can swap in this complete set of Dana 60 front axle shafts. The kit uses an SPL55-3X joint and is machined for full circle snap rings. It needs 35 spline aftermarket locking hubs. The shafts are chromoly, forged from 4340 alloy, with extra material around the U-joint cap so the yoke resists distortion. It fits 1975–1993 Dodge W300 and W350 trucks with a Dana 60 front.
A Dana 60 is a heavy duty front axle commonly found under full-size four-wheel-drive trucks of this era. The 35 spline shafts are larger than those used on many lighter axles, so the hubs and joints must match that size. The kit pairs the SPL55-3X joint with full circle snap rings and needs 35 spline aftermarket locking hubs. Those parts work together as a set.
Key features
- Dana 60 front axle kit in chromoly
- 35 splines
- SPL55-3X joint
- Machined for full circle snap rings
- Needs 35 spline aftermarket locking hubs
- No differential included
Heavy duty truck front ends
Full-size trucks with a Dana 60 front carry heavy loads and often run larger tires than the factory fit. The front end sees hard starts, deep ruts and sudden braking, so the shafts and joints take repeated stress. When a shaft breaks on the trail, the truck is stuck until it can be towed, which is why many owners plan the upgrade ahead of time.
Matching the hubs is the step most often missed. A 35 spline shaft will not work with lighter locking hubs, and the hub choice also sets how the axle is engaged. Look at the hub housings and count the splines before buying. Once the new hubs are in, grease them and tighten the fasteners with a torque wrench before the first drive.
Joint care matters as much as the shafts. Keep the SPL55-3X joint greased, look for torn boots or play, and replace any worn joint at the same time as the shafts. Snap rings should seat fully in their grooves. A ring that is loose or badly worn should be replaced before the axle goes back into service.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 98-2034-002 |
| UPC | 631410108347 |
| Part type | Front axle kit |
| Material | Chromoly (4340 alloy) |
| Axle | Dana 60 |
| Axle location | Front |
| Spline count | 35 splines |
| U-joint | SPL55-3X |
| Snap rings | Full circle |
| Differential included | None |
Vehicle fitment
It fits 1975–1980 Dodge W300 and 1981–1993 Dodge W350 trucks equipped with the Dana 60 front axle.
Other Dodge trucks, two-wheel-drive models and trucks with a different front axle are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The locking hubs on the truck have to be 35 spline aftermarket units to mate with these shafts, so check the hubs before ordering. Use the supplied joint style and full circle snap rings together.
What’s included
Not included: The 35 spline aftermarket locking hubs the kit requires.





