Overview
The G2 Axle and Gear 2-2028-355 is a 3.55 ratio ring and pinion for the rear Chrysler 9.25 Inch axle. In this set the pinion turns 3.55 times for every ring gear revolution, a moderate setting that adds low-speed pull.
The set fits the rear Chrysler 9.25 Inch axle. It is intended for oversized tires with high-performance engines and uses modern materials and manufacturing methods. Vehicle models and years are not identified, so verify that housing before purchase.
Key features
- 3.55 gear ratio for the Chrysler 9.25 Inch rear axle
- Rear axle location
- Matched ring gear and pinion supplied together
- Designed for oversized tires and high-performance engines.
- Built with current manufacturing methods and materials.
Choosing between close ratios
Gears close together on the ratio scale feel similar on the road, but a 3.55 set gives a little more low-speed pull than a lower one. That helps with light trailers, mountain grades and off-road use with moderate tires. Highway speed brings slightly higher engine rpm, which is a fair trade for most drivers who use the truck for mixed work.
Before swapping, look at tire diameter, axle load and the transmission’s gearing. The 9.25 inch carrier is a robust unit, but a new set still needs proper pinion depth and backlash. Inspect the carrier bearings and axle seals while the housing is open, and renew any part that shows heat marks or roughness.
- Compare tire diameter first
- Check carrier bearing condition
- Keep early loads light
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2028-355 |
| UPC | 631410093766 |
| Axle type | Chrysler 9.25 Inches |
| Axle location | Rear |
| Gear ratio | 3.55 |
| Axle manufacturer | Chrysler |
Vehicle fitment
Fitment is not tied to specific vehicles. The 3.55 set is matched to the Chrysler 9.25 Inch rear axle, so confirm that housing and its carrier on your vehicle before ordering. Any axle that is not a 9.25 Inch Chrysler needs its own fit check.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tooth contact and backlash on a 3.55 set call for a gear shop with setup tools. Allow a break-in run before loaded towing.
What’s included
One 3.55 ring and pinion set for the Chrysler 9.25 Inch rear axle, part number 2-2028-355.
Not included: Carrier bearings, shims and hardware for the 3.55 rear set are not part of this set.















