Overview
The G2 Axle and Gear 25-2028 is a minor ring and pinion installation kit for the Chrysler 9.25 Inches rear axle.
Rear Chrysler 9.25 inch axles are covered by the 25-2028. G2 includes a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, but no bearings.
For rear Chrysler 9.25 inch axles with bearings in good condition, the 25-2028 is the minor option. The kit contains a proper shim kit, a pinion nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, which together let the gears be re-shimmed and the housing sealed again. Because the Chrysler 9.25 inch axle is listed here for the rear only, a front 9.25 inch unit needs different parts.
Key features
- Minor kit for the Chrysler 9.25 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Choosing a minor kit
A minor kit fits a gear change where the carrier bearings and races are still sound. Its value is in the parts that get used up during a swap: the pinion nut, crush sleeve and seal, ring gear bolts, and the sealer and thread locker that keep the housing closed and the bolts secure.
Before buying, look at the bearings on the pinion and carrier. Roughness, play or heat marks mean a master kit or new bearings are the better path. Keep the old shims measured for reference, since a new setup often needs a few shim changes before the contact pattern looks right.
- Check bearing and race condition first
- Keep old shims for measurement reference
- Replace the crush sleeve on every install
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2028 |
| UPC | 631410095012 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | Chrysler 9.25 Inches |
| Axle manufacturer | Chrysler |
| Manufacturer part number | G/225-2028 |
Vehicle fitment
This kit is made for the rear Chrysler 9.25 inch axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Count on pressing the pinion head and setting preload with the new crush sleeve. Finish by painting a few teeth with compound to read the pattern.
Before starting the 25-2028 job on the Chrysler 9.25 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2028 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2028 is a minor kit for the Chrysler 9.25 Inches axle.








