Overview
The G2 Axle and Gear 35-2021F is a master ring and pinion installation kit with bearings for the GM 8.5-inch (10 bolt) axle, for the front axle position.
The 35-2021F contains the parts needed to install a ring and pinion properly, with pinion and carrier bearings along with the shims, nut, seal and compounds. Some of these parts are hard to find and rarely stocked by auto parts stores. It is for use in 77-91 8.5-inch front axles only. The ring and pinion gear set itself is not included.
Key features
- Master kit with bearings for the GM 8.5-inch (10 bolt) axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- For use in 77-91 8.5-inch front axles only
Front axle considerations
Front 8.5-inch gears carry steering and drive loads at the same time, which makes pinion depth and carrier preload especially important. Because the front differential sits close to the steering components, check for play in the axle shafts and U-joints before opening the housing. Solving those problems first keeps the new gears from wearing unevenly.
A front gear job also benefits from a careful look at the axle seals and vent. Any water or grit in the housing will shorten bearing life, so clean the housing well and replace the seals at the same time. Keep gear oil at the correct level after installation and check it again after the first drives.
- Check axle shaft and U-joint play first
- Replace the front axle seals during the job
- Recheck gear oil level after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2021F |
| UPC | 631410095661 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 8.5-inch (10 bolt) |
| Axle location | Front |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Listing condition | For use in 77-91 8.5-inch front axles only |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2021F is identified by axle rather than by vehicle: it is made for the GM 8.5-inch (10 bolt) axle in the front position, limited to 77-91 8.5-inch front axles.
It is not made for other axle designs or sizes. Compare the axle’s year range and bolt pattern with your housing before buying.
Installation notes
A master kit such as the 35-2021F rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2021F are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2021F: ring and pinion gear set.












