Overview
The 2-2015-456 is a 4.56 ratio ring and pinion for GM 10 Bolt rear axles. It is made for a 7.6 inch axle and needs a carrier rated 3.23 and up. A lower-ratio carrier is not a match for this set, so check the carrier ratio before buying.
The set is made to original equipment specifications and built to handle oversized tires and high-performance engines. It is made from heat treated 8620 steel and finished with double shot peening and double lapping.
Key features
- 4.56 gear ratio for GM 10 Bolt rear axles
- Requires a 3.23 and up carrier.
- Computer heat treated 8620 steel
- Double shot peened, then double lapped
- Made to original equipment specifications.
- The set carries a 10 year warranty.
Break-in and carrier setup
A 4.56 ratio is steep, so the gears see more load and heat than a numerically lower set. Pattern checks and backlash measurements should be done before the axle goes back into service. Once installed, a gentle break-in run lets the tooth surfaces settle before heavy loads or sustained towing begin.
The carrier is the main compatibility question for this set. A carrier that is too low a ratio will not work with these gears, so confirm the carrier rating before buying. Carrier bearings, pinion bearings, shims and seals are often replaced together with the gears, which keeps the setup clean and avoids reworking the housing a second time. Inspect the old pinion for pitting and the ring gear for chipped teeth as signs the old set was worn.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2015-456 |
| UPC | 631410112658 |
| Axle type | GM 10 Bolt, 7.5 inch or 7.625 inch ring gear |
| Fits axle | 7.6 in. axle |
| Carrier requirement | 3.23 and up |
| Gear ratio | 4.56 |
| Material | Computer heat treated 8620 steel |
| Finish | Double shot peened, double lapped |
| Axle location | Rear |
| Warranty | 10 year |
Vehicle fitment
Confirm the axle and the carrier ratio on your vehicle before ordering. This 4.56 set is made for GM 10 Bolt rear axles with a 3.23 and up carrier, and a carrier lower than 3.23 is not a fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.56 set is a steep ratio, and its tooth contact and carrier preload need professional setup. Plan for a gear shop and a break-in period before heavy towing.
What’s included
One 4.56 ring and pinion set for GM 10 Bolt rear axles, part number 2-2015-456.
Not included: Carrier bearings, shims and installation hardware are not included with the 4.56 set and need separate sourcing.















