Overview
The G2 Axle and Gear 2-2015-410 is a 4.10 ratio ring and pinion for GM 10 Bolt rear axles. Every full turn of the ring gear takes 4.10 turns of the pinion, so the ratio multiplies engine torque at the wheels and suits heavier loads and larger tires than a lower gear would.
The set covers both the 7.625 inch and 7.5 inch 10 Bolt ring gear versions and is built for oversized tires and high-performance engines. Measure the ring gear on your axle and confirm the carrier before buying.
Key features
- 4.10 gear ratio for the GM 10 Bolt rear axle
- Covers 7.5 inch and 7.625 inch ring gear housings
- Ring gear and pinion supplied as a matched set
- Built for oversized tires and high-performance engines.
- Rear axle location
Living with a 4.10 ratio
A 4.10 set moves the engine’s power toward the wheels at lower speeds, which helps with towing, hill climbs and crawling over rough ground. The cost shows up at cruise, where the engine runs faster for the same road speed. Many owners plan for that by checking cooling and transmission temperatures on longer trips with a load.
Gear setup matters more than gear size alone. Tooth contact and backlash should be checked when the new set is installed, and the pinion and carrier bearings need correct preload. Expect the gears to make some noise during the first few hundred miles while they seat. A change in whine, heat or vibration after that is worth investigating, because it often points to a setup problem that is easier to correct early.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2015-410 |
| UPC | 631410093506 |
| Axle type | GM 10 Bolt, 7.625 inch or 7.5 inch ring gear |
| Axle location | Rear |
| Gear ratio | 4.10 |
| Axle manufacturer | GM |
Vehicle fitment
Confirm the ring gear size and carrier on your truck or SUV before ordering. This 4.10 set is made for GM 10 Bolt rear axles only.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.10 gear set needs accurate tooth contact and backlash, and the carrier bearings must be preloaded to spec. A gear shop is the practical installer, followed by a break-in period.
What’s included
One 4.10 ring and pinion set for GM 10 Bolt rear axles, part number 2-2015-410.
Not included: Carrier bearings, shims and installation hardware are not included with the 4.10 GM 10 Bolt set.
















