Overview
The G2 Dana 44 TJ Rubicon 5.13 Ratio Ring and Pinion, part number 2-2045-513, is a 5.13-ratio gear set for the rear Dana 44 Rubicon axle in the Jeep Wrangler TJ.
G2 says its gears are engineered for demanding use and built from the latest technology and materials, and the set is for a Dana 44 that came in the TJ.
Key features
- 5.13 gear ratio
- Dana 44 TJ Rubicon axle
- Fits the rear axle location
- Part number 2-2045-513
Rubicon axle upkeep
The Dana 44 Rubicon axle is often used on trails where articulation and load change quickly, so the ring and pinion sees hard use. A 5.13 ratio gives strong low-speed pulling but raises engine speed at highway cruising. Think about your tire size and driving mix before deciding whether this gearing matches how you use the truck.
Routine checks keep the axle healthy. After trail runs, look at the axle vent and cover for leaks, and check the fluid for metal flakes. If the gears are replaced, pinion bearings and the carrier bearings are commonly serviced at the same time, which saves a second teardown later.
- Check for leaks around the cover and seals
- Look for metal flakes in the gear oil
- Inspect pinion and carrier bearings when the gears are replaced
- Keep the axle vent clear
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2045-513 |
| UPC | 631410094442 |
| Axle type | Dana 44 TJ Rubicon |
| Axle location | Rear |
| Gear ratio | 5.13 |
Vehicle fitment
This 5.13 set is for the Dana 44 axle of the Jeep Wrangler TJ (1997-2006). The fitment covers the TJ model years rather than a single trim.
Confirm your vehicle’s year, model and trim before ordering, and check that the axle is the Dana 44 used in the TJ.
Installation notes
Set the mesh, backlash and pinion depth on this 5.13 set with the right tools, and allow for a break-in period before towing.















