Overview
The G2 Dana 60 Front Reverse Thick 5.13 Ratio Ring and Pinion, part 2-2034-513RX, is a front reverse thick gear set at 5.13 for the Dana 60 axle.
The gears are computer heat treated 8620 steel, double shot peened and double lapped, and built to original equipment specifications. The set is for 4.10 and down carriers.
Key features
- 5.13 gear ratio
- Front axle position
- Reverse thick design
- For 4.10 and down carriers
Dana 60 reverse setup
Thick tooth designs are generally chosen for heavier loads, but they still need to match the carrier and the axle housing. Confirm the carrier ratio and the front axle layout before buying, since a set that does not fit the carrier cannot be corrected by careful setup.
Front Dana 60 installs also involve the pinion seal, the carrier bearings and the axle shaft seals. Set the pinion depth and preload first, then backlash, then check tooth contact. Replace worn bearings during the job, because a fresh set of gears runs best with fresh support.
- Check the carrier ratio before buying
- Inspect the front pinion seal for leaks
- Replace worn carrier bearings during setup
- Verify backlash and tooth contact before closing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-513RX |
| UPC | 631410094237 |
| Axle type | Dana 60 |
| Axle location | Front |
| Gear ratio | 5.13 |
| Carrier | 4.10 and down |
| Warranty | 10 years |
Vehicle fitment
Universal fit is listed, but no vehicle is named. The set is for the front Dana 60 at 5.13, so confirm the axle and carrier size before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the carrier is 4.10 or lower before buying, then set pinion depth and preload on the reverse design.
What’s included
One ring and pinion set.
















