Overview
The G2 Axle and Gear Toyota 8.75 Rear 5.29 Ratio Ring and Pinion, part number G/22-2156-529, is a rear gear set with a 5.29 ratio for the Toyota 8.75-inch rear axle.
G2 built this range for oversized tires and high-power engines, using current materials and manufacturing methods. Confirm the rear axle type and 5.29 ratio against your housing, since no vehicle is attached to this set.
Key features
- 5.29 gear ratio
- Rear axle location
- Toyota 8.75 axle type
- Marketed by G2 for oversized tires and high-power engines
Pinion depth and backlash
Pinion depth and backlash are the two settings that decide whether a rear ring and pinion runs quietly. Pinion depth is set by the shim pack behind the pinion head, and backlash is set by moving the ring gear toward or away from the pinion. Both must be checked with the gears in place, since small changes can throw off the contact pattern.
Rear sets on a Toyota 8.75 axle are often paired with new carrier bearings, a fresh pinion seal and clean gear oil. Inspect the old gears for pitting, uneven wear or chipped teeth before deciding whether to reuse anything. A gradual break-in helps the new teeth seat, so avoid hard acceleration and heavy towing for the first stretch of driving.
- Pinion shim pack
- Backlash measured with the gears in mesh
- Contact pattern check
- Clean gear oil after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | G/22-2156-529 |
| Axle location | Rear |
| Axle type | Toyota 8.75 |
| Gear ratio | 5.29 |
| Popular axle manufacturer | Toyota |
Vehicle fitment
This is a rear Toyota 8.75 set with a 5.29 ratio, so check the housing against it before choosing. Front Toyota 8-inch IFS axles are outside its use.
Front Toyota 8-inch IFS axles are not covered by this rear set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use a professional for pinion depth, backlash and preload on this 5.29 set. A gradual break-in should follow the setup.
What’s included
This set is the gears only, so bearings, shims and seals need to be sourced separately.

















