Overview
The G2 Axle and Gear 2-2035-354 is a 3.54 ratio ring and pinion for the rear Dana 70 axle. The pinion turns 3.54 times per revolution of the ring gear, a moderate ratio that keeps engine rpm lower at highway speed than steeper Dana 70 gears.
G2 makes this set for the Dana 70 in the rear position. The Performance Ring and Pinion line is built for oversized tires and high-performance engines, using current materials and manufacturing methods. Confirm the housing, carrier and axle location on your vehicle before ordering.
Key features
- 3.54 gear ratio for the Dana 70 rear axle
- Rear axle location
- Ring gear and pinion supplied as one set
- Designed for oversized tires and high-performance engines.
- Made with current materials and methods.
Rear axle gearing basics
A 3.54 ratio is a moderate setting for the rear axle. The pinion turns fewer times per ring gear revolution than a steeper set, so engine speed stays lower at highway speed. The trade is less low-speed pulling force, which matters when the vehicle tows, climbs or carries heavy cargo.
Choosing gears is easiest when the tire size and typical use are known. Taller tires already change the effective ratio, so the gear choice should follow the real wheel diameter. Older gears should also be checked for pitting and chipped teeth, since worn teeth can make a new set noisy or short-lived.
- Measure the old gears before ordering
- Check axle shaft and bearing wear
- Compare the ratio against your tire size
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2035-354 |
| UPC | 631410094251 |
| Axle type | Dana 70 |
| Axle location | Rear |
| Gear ratio | 3.54 |
| Axle manufacturer | Dana |
Vehicle fitment
The 3.54 set is made for the rear Dana 70 axle. Confirm the housing, carrier and axle location on your vehicle first. Axles that do not clearly match the Dana 70 need a different set.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and carrier preload must be set with measuring tools, so a gear shop is the practical installer. Allow a break-in period before loaded use.
What’s included
One 3.54 ring and pinion set for the Dana 70 rear axle, part number 2-2035-354.
Not included: Carrier bearings and pinion shims are not included with the Dana 70 3.54 set.
















