Overview
The G2 Axle and Gear 4-TJ-410 is a front and rear ring and pinion kit with a 4.10 ratio for non-Rubicon Jeep Wrangler (TJ) models. It includes gear sets for the Dana 30 front axle and the Dana 35 rear axle, along with matched Master Installation Kits.
The 4.10 ratio is the mildest of the three TJ ratios offered in this G2 family, and it is the sort of gearing used to compensate for a modest increase in tire size. G2 describes its sets as computer heat treated 8620 steel that has been double shot peened and double lapped, and covers them with a limited lifetime warranty.
The TJ chassis code covers the 1997-2006 Jeep Wrangler (TJ).
Key features
- 4.10 ratio, front and rear
- For non-Rubicon models
- Dana 30 front axle and Dana 35 rear axle
- Matched Master Installation Kit for each axle
- Computer heat treated 8620 steel
- Double shot peened and lapped
- Built to O.E. specifications
Break-in and first service
New ring and pinion gears need a gentle break-in before they carry heavy loads. Easy throttle, moderate speeds and avoiding hard launches or long tows during the first stretch of use let the gear faces settle into a steady contact pattern. Skipping this period is a common cause of early noise in a freshly set-up axle.
Plan for a gear oil change once the break-in is complete. The first fluid collects fine metal from the early wear, so replacing it keeps the new gears clean. A brief inspection of the axle seals and the drain plug during that service catches small leaks before they become a problem on the trail.
- Gentle driving during the first use
- Gear oil change after break-in
- Seal and drain plug check at first service
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-TJ-410 |
| UPC | 700007521591 |
| Gear ratio | 4.10 |
| Front axle | Dana 30 TJ |
| Rear axle | Dana 35 |
| Application | Non-Rubicon models |
| Material | Computer heat treated 8620 steel |
| Finishing | Double shot peened, double lapped |
| Warranty | Limited lifetime (G2) |
G2 gives no tooth counts, set weight or installation kit breakdown.
Vehicle fitment
The kit fits the Jeep Wrangler (TJ), 1997-2006, as a non-Rubicon model with Dana 30 and Dana 35 axles.
Trim does not narrow this fit, so check the year, model and trim before ordering.
Not covered: Rubicon models and other Wrangler generations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting up a 4.10 kit calls for pinion depth, backlash and pattern checks at both ends; most owners hand this to a gear shop. Break in the new gears with gentle driving.
Use each Master Installation Kit with its matching axle.
What’s included
- Front ring and pinion set, 4.10
- Rear ring and pinion set, 4.10
- Front Master Installation Kit
- Rear Master Installation Kit
Not included: gear oil and other items not in the kit.












