Overview
The G2 Axle and Gear 65-2023H is an open differential carrier for GM 14 Bolt 10.5 Inch rear axles. It is a direct replacement for the factory differential, and it suits a case that matches your gear ratio.
G2 Axle and Gear gives the axle location as rear, the axle type as GM 14 Bolt 10.5 Inches, and the differential type as open differential case only with an empty spline.
Key features
- Direct replacement for the factory differential, per the brand
- Open differential case only
- GM 14 Bolt 10.5 Inch rear axle type
- Empty spline case
- Suited to repairs
Matching a GM 14 Bolt carrier
The GM 14 Bolt axle has a carrier that bolts into the axle housing, and the ring gear, pinion and bearing setup determine how smooth and quiet it runs. When replacing the case, check the bearing bores, the bolt holes and the pinion location against the housing you already have. A ring gear that fits the new landing and correctly set backlash are both needed before the axle is used.
Gear ratio matters as much as fit. Changing ratio alters how the vehicle accelerates and how the engine turns at speed, so keep the ratio consistent unless the change is intended. Parts often replaced in the same job include the carrier bearings, pinion seal and axle bearings. Work with a professional for gear mesh and preload, and fill with the correct lubricant afterward.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 65-2023H |
| UPC | 631410096408 |
| Axle type | GM 14 Bolt 10.5 Inches |
| Axle location | Rear |
| Axle spline | Empty case |
| Differential type | Open differential case only |
Vehicle fitment
This is an axle carrier for the GM 14 Bolt 10.5 Inch axle type and is universal fit. Check your axle type and ring gear landing before fitting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The open case is empty, so ring gear, pinion and bearing setup is needed, and professional gear set-up is recommended.
What’s included
The open differential carrier case only.
Not included: Ring gear, pinion and bearings are not included.











