Overview
The G2 Axle and Gear 2-2024-488 is a 4.88 ratio rear ring and pinion for the 11.5 inch American Axle Manufacturing rear axle. It fits the Chrysler 11.5 inch housing and the GM 14 bolt 11.5 inch AAM type, and it works with all ratio carriers.
G2 describes these gears as built for oversized tires and high performance engines, using computer heat treated 8620 steel with double shot peened and double lapped surfaces. Because the 11.5 inch case is a larger housing, match it to the axle before ordering.
Key features
- 4.88 ratio rear ring and pinion
- Fits the Chrysler 11.5 inch housing
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Choosing the right setup
A larger rear housing such as the 11.5 inch case carries more load into the carrier and the axle shafts, so the gear set works best when the rest of the axle is in good order. Before installing a 4.88 set, check the carrier bearings, the pinion bearing, and the axle shaft bearings for play or roughness.
Gear ratio changes how the engine works under load. A numerically higher ratio like 4.88 gives more pulling force at low speed and tends to raise engine speed on the highway. Many owners who run larger tires consider matching the ratio to tire diameter and to the transmission gearing before settling on a set.
- Inspect carrier and axle shaft bearings before installing
- Match the ratio to your tire diameter and driving use
- Check the cover gasket and fluid level after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2024-488 |
| UPC | 631410093650 |
| Gear ratio | 4.88 |
| Axle location | Rear |
| Axle type | Chrysler 11.5 inch AAM; GM 14 bolt 11.5 inch (AAM) |
| Popular axle manufacturer | American Axle Manufacturing |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is a 4.88 ratio set for the Chrysler 11.5 inch AAM and GM 14 bolt 11.5 inch (AAM) housings. Confirm the housing and your vehicle’s year, model and trim before ordering.
Only the Chrysler 11.5 inch AAM; GM 14 bolt 11.5 inch (AAM) is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth, backlash and bearing preload on the 11.5 inch AAM gears with a driveline shop, then break the 4.88 set in before full loads.
What’s included
A matched ring and pinion for the 11.5 inch AAM rear axle.
















