Overview
It is a rear gear set at 4.56 for a 10.5 inch 14 bolt axle, and it is also made for the Chrysler 10.25 inch AAM rear.
The O.E.M. series is designed to run cooler and quieter than typical aftermarket gears, and it is produced to original equipment manufacturer standards.
Key features
- 4.56 gear ratio
- Rear axle position
- Built to the O.E.M. series design
- Works with all ratio carriers
- Double shot peened and double lapped
Axle identification before buying
Ring gear diameter and bolt count are the first checks for a 14 bolt rear, because a 10.5 inch and a 10.25 inch housing can look similar at a glance. Measure the ring gear or read the axle tag before ordering. Pinion yoke size and axle bearing type also matter when the gears are swapped.
A quieter, cooler running gear set helps most when the rest of the drivetrain is in good shape. Check the carrier bearings, pinion seal and axle shaft seals while the housing is open, and fill with fresh gear oil that suits the axle. Refresh the gear oil again after the first trips of regular use.
- Measure ring gear diameter before ordering
- Count the axle bolts on the housing cover
- Check the pinion yoke size
- Use gear oil suited to the axle type
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2097-456 |
| UPC | 631410093162 |
| Make | Dodge and Chrysler |
| Axle size | 10.5 inch 14 bolt; 10.25 inch AAM |
| Axle location | Rear |
| Gear ratio | 4.56 |
Vehicle fitment
The set is made for a rear 10.5 inch 14 bolt axle and a 10.25 inch AAM rear. Confirm the axle type and bolt count for your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the ring gear diameter and bolt count against your axle before ordering.
What’s included
One ring and pinion set.














