Overview
The G2 Dana 44 JK Rear 4.88 Ring and Pinion, part number 2-2052-488, is a 4.88-ratio gear set for the rear Dana 44 axle in the Jeep Wrangler JK. It is built for the rear axle position.
These gear sets are built for demanding use, with current technology and materials in the gears.
Key features
- 4.88 gear ratio
- Dana 44 JK rear axle
- Rear axle location
Break-in and first drives
A 4.88 rear set changes engine speed at a given road speed, which is noticeable on the highway and during slow crawling. Because the gears are new, the first drives matter for how the set seats. Keep loads moderate and avoid hard launches until the teeth have settled, and listen for any change in noise as you go.
After break-in, a fluid change and a mesh check help confirm the setup. Look for leaks at the cover and axle seals, and recheck the pinion nut and carrier bolts. Keeping a record of the setup and the first service date makes later inspections easier to plan.
- Keep loads moderate during early drives
- Avoid hard launches until the teeth settle
- Change gear oil after break-in
- Recheck pinion nut and carrier bolts
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2052-488 |
| UPC | 631410094602 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Gear ratio | 4.88 |
Vehicle fitment
This rear set is for the Dana 44 axle of the Jeep Wrangler JK (2007-2018). It covers the JK model years regardless of trim.
Confirm your vehicle’s year, model and trim before ordering, and check the axle location is rear.
Installation notes
Set the backlash and pinion depth on the 4.88 rear set before installing it, and expect a break-in period on the new gears.















