Overview
The G2 Axle and Gear 95-2011-004 is a big bearing Ford 9 inch rear driver side axle shaft with 28 splines, made for the 1966–1975 Ford Bronco. It is the driver side partner in a big bearing pair, and its steel is forged and heat treated beyond OEM specifications.
The 95-2011-004 fits the rear Ford 9 inch axle of the Bronco and does not include wheel studs. Its passenger side partner is the 95-2011-003. The big bearing style separates it from small bearing shafts, so confirm your axle’s bearing before ordering. Covered years run 1966 through 1975 with 1973 excluded, plus the 1975 Bronco Sport. Owners who need both rear shafts with big bearings will also need the 95-2011-003.
Key features
- Driver side rear axle shaft for the Ford 9 inch axle
- 28 splines
- Big bearing design
- Forged from high grade alloy steel.
- Heat treated to exceed OEM specifications.
Driver side shaft fitting
The driver side and passenger side shafts are separate parts, and each side needs the correct shaft for its position. Lay the old shaft beside the new one before installing and check that the splines, flange and length line up. A mismatched side can leave the shaft sitting out of position inside the axle housing.
Before the shaft goes in, clean the axle flange and check the seal surface for grooves. A small scratch can start a leak, and a leaking seal lets grease escape from the bearing. If the old shaft was bent or the bearing is noisy, inspect the partner shaft as well, since both sides carry the same load.
Tighten the retaining hardware fully, then re-check it after the first short drive and again after the first trail outings.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2011-004 |
| UPC | 631410105834 |
| Axle manufacturer | Ford |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | Ford 9 Inches |
| Position | Rear |
| Spline count | 28 Splines |
| Bearing | Big bearing |
| Material | High grade alloy steel, forged |
| Applications noted | 1966-1975 Ford Bronco |
Vehicle fitment
It fits the early Ford Bronco in the years shown below.
- 1966–1972, 1974–1975 Ford Bronco (Base, Custom, Northland, Ranger)
- 1975 Ford Bronco Sport
Years run 1966–1972 and 1974–1975 plus the 1975 Bronco Sport, with 1973 missing. Small bearing Broncos are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear axle shaft.
Not included: wheel studs.







