Overview
The G2 Axle and Gear 95-2010-003 is a GM 9.5 inch 14 bolt rear axle shaft with 33 splines for 1988–1998 Chevrolet K1500 and K2500 and GMC K2500 trucks. The shaft is designed for high torque loads and is forged from high grade alloy steel, heat treated to exceed OEM specifications. It has rolled splines.
This shaft suits either side of the GM 14 bolt rear axle and uses 14mm press fit wheel studs, which G2 does not include. The 95-2010-003 differs from the 95-2010-001 mainly in stud size and truck generation, with 14mm studs and the 1988–1998 K-series trucks. It is a rear shaft for the GM 14 bolt axle, usable on either side, and its 33 splines match the larger spline option on the 14 bolt. Two-wheel-drive C-series trucks are not included in the list.
Key features
- Rear axle shaft for the GM 9.5 inch 14 bolt axle
- 33 splines
- Driver or passenger side
- Forged from high grade alloy steel.
- Heat treated to exceed OEM specifications.
- Uses 14mm press fit wheel studs
Hub and stud preparation
Axle shafts in this style carry the wheel load through the splines and the flange, so the surface where the wheel stud sits has to be clean and flat. Check the hub bore and flange for rust or burrs before fitting the new shaft. Use a press tool sized for the studs so the shaft is not damaged during install.
Rear axle shafts take the drive torque when the truck is under load, so the spline fit and the bearing seat deserve a close look at each step. Replace worn bearings and seals while the axle is apart, and keep the shaft clean until it is installed. A runout check on the flange can help when the old part is not reliable.
- Clean the hub flange before fitting
- Use a press tool sized to the stud
- Check the spline fit before final assembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2010-003 |
| UPC | 631410106121 |
| Axle manufacturer | GM |
| Shaft location | Driver Or Passenger |
| Axle position | Rear |
| Axle type | GM 14 Bolt 9.5 Inches |
| Position | Rear |
| Spline count | 33 Splines |
| Wheel stud size | 14mm press fit |
| Material | High grade alloy steel, forged |
| Applications noted | 1988-1998 K1500/2500 |
Vehicle fitment
It fits three four-wheel-drive truck lines.
- 1988–1998 Chevrolet K1500 (Base, Cheyenne, Scottsdale, Silverado, Sport, WT)
- 1988–1998 Chevrolet K2500 (Base, Cheyenne, Scottsdale, Silverado, WT)
- 1988–1998 GMC K2500 (Sierra, Sierra SL, Sierra SLE, Sierra SLT, Sierra SLX)
Only the 1988–1998 K1500, K2500 and GMC K2500 are covered. Two-wheel-drive C-series trucks and other axle sizes are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Press fit 14mm wheel studs are needed, and G2 does not supply them with this shaft.
What’s included
One rear axle shaft.
Not included: wheel studs.








