Overview
The G2 Axle and Gear 95-2021-002 is a rear replacement axle shaft for the GM 10 bolt 8.5 inch axle in the 1981–1987 GM K10 four-wheel-drive truck. It has 28 splines and a 31.31 inch overall length.
It is forged from high grade alloy steel and heat treated, which suits high-torque use with larger tires.
The 95-2021-002 gives the K10 owner a stated 31.31 inch overall length to compare against the shaft being replaced. With 28 splines, it fits the GM 10 bolt 8.5 inch rear axle on either side. G2 Axle and Gear says its shafts are built to survive high-torque use, and it points to rolled splines and better materials as the reason owners can fit larger tires.
Key features
- 28 splines
- 31.31 inch overall length
- Either driver or passenger side
- GM 10 bolt 8.5 inch rear axle
- Forged alloy steel, heat treated.
- Wheel studs not included
Measuring before you buy
The overall length of an axle shaft matters as much as its spline count. Measure the old shaft from end to end, including the splined end and the flange, and compare that length with the new part before buying. A shaft that is too short will not reach the differential side gear, and one that is too long can bind the axle when the suspension moves.
Four-wheel-drive K10 trucks often use a shaft that has been replaced before, so check the hub, the bearing and the axle tube for corrosion or old repairs. Clean the splines and apply a thin coat of axle spline grease. Inspect the seal for leaks and replace it if it is hardened. Keep the lug nut torque within the range your wheels and hubs require.
- Measure the old shaft end to end before buying
- Clean the splines before fitting the new shaft
- Inspect the axle tube for corrosion
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2021-002 |
| UPC | 631410106022 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 8.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 28 |
| Overall length | 31.31 inches |
| Wheel studs | Not included |
| Stated application | 1981-1987 GM K10 4 WD |
Vehicle fitment
It fits the 1981–1986 Chevrolet K10 and the 1987 Chevrolet V10, both four-wheel-drive trucks.
Only the four-wheel-drive K10 and V10 trucks are named; two-wheel-drive C10 trucks are not. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Measure your old shaft against the 31.31 inch overall length before installing.
- Wheel studs are not included.
What’s included
One rear axle shaft that fits either side (95-2021-002).
Not included: wheel studs for the 95-2021-002.











