Overview
The G2 97-2032-001 is a chromoly outer axle shaft for Dana 30 and Dana 44 front axles. It has 27 splines, an overall length of 8.72 inches and accepts a 5-760X U-joint. It fits both the driver and passenger sides.
The shaft fits 1972 to 1986 Jeep CJ models, covering the CJ5 from 1972 to 1983 and the CJ7 from 1976 to 1986.
G2 says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications, and that they are engineered to handle the added load of high torque applications. The big spline options, rolled splines and better materials are said to let owners run larger tires with less risk of failure.
Key features
- Chromoly outer shaft with 27 splines
- Fits driver and passenger sides
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- Forged and heat treated alloy steel
Signs the axle shaft is worn
An outer axle shaft carries the wheel torque to the hub, and wear usually shows first at the splines and the U-joint end. Clicking or clunking when turning from a stop, vibration under acceleration, and grease escaping from the joint are common early signs. Shafts that are twisted from a hard hit can also cause a wobble that feels like a bad tire.
When choosing a shaft for a heavier setup, look at how the spline count and the U-joint size match the axle you are replacing. Full circle clips hold the shaft in the hub, so check the clip groove for wear each time the shaft comes out. Replacing the U-joint and clips at the same time as the shaft is a practical way to avoid a second tear-down.
- Clicking or clunking when turning from a stop
- Vibration that increases under acceleration
- Grease leaking from the U-joint or hub seal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-001 |
| UPC | 631410097030 |
| Axle location | Front |
| Axle types | Dana 30 standard and Dana 44 |
| Spline | 27 |
| Overall length | 8.72 inches |
| U-joint | 5-760X |
| Retainer | Machined for full circle clips |
Vehicle fitment
It fits the 1972 to 1983 Jeep CJ5 and the 1976 to 1986 Jeep CJ7.
The Scout is not part of the fitment for this shaft. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is machined for full circle clips and a 5-760X U-joint, so check that the U-joint and clip set match before installing.
What’s included
The shaft fits both the driver and passenger sides. Check the package contents against your installation before starting.









