Overview
The 95-2011-002 is a small bearing Ford 9 inch rear driver side axle shaft with 28 splines for the 1966–1975 Ford Bronco. It is forged from high grade alloy steel and heat treated to exceed OEM specifications, which suits high torque use.
The 95-2011-002 is the small bearing driver side shaft for the Bronco’s Ford 9 inch rear axle. Wheel studs are not included. The bearing size separates it from the big bearing driver side shaft, which carries a different part number, while both use 28 splines. A Bronco rear axle with small bearings needs a passenger side shaft as well, sold under a separate part number.
Key features
- Driver side rear axle shaft for the Ford 9 inch axle
- 28 splines
- Small bearing design
- Forged from high grade alloy steel.
- Heat treated to exceed OEM specifications.
Small versus big bearing axles
The bearing size on a Ford 9 inch axle decides which shaft fits. Small bearing and big bearing shafts can look alike at a glance, but they are not interchangeable. Before buying, measure the bearing journal on the old shaft and confirm the bearing type in the axle housing. A matching bearing keeps the shaft seated correctly and avoids a loose fit that can wear the bore.
A rebuild is a good time to check the rest of the rear end. Inspect the axle bearing, seal and retainer for wear, and look at the spline ends for twisting or fretting. If the bearing is worn, replace it along with the shaft. Wheel studs are a separate purchase, so plan for them before the wheel goes back on. Clean the axle tube opening and apply fresh gear oil to the seal lip before installation.
- Confirm the bearing type before ordering
- Inspect the seal and retainer
- Replace worn wheel studs when fitting the shaft
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2011-002 |
| UPC | 631410105810 |
| Axle manufacturer | Ford |
| Shaft location | Driver Side |
| Axle position | Rear |
| Axle type | Ford 9 Inches |
| Position | Rear |
| Spline count | 28 Splines |
| Bearing | Small bearing |
| Material | High grade alloy steel, forged |
| Applications noted | 1966-1975 Ford Bronco |
Vehicle fitment
It fits the early Ford Bronco, including the 1975 Bronco Sport. 1973 models are not covered.
- 1966–1972, 1974–1975 Ford Bronco (Base, Custom, Northland, Ranger)
- 1975 Ford Bronco Sport
The list runs 1966–1972 and 1974–1975 and includes the 1975 Bronco Sport; 1973 is absent. The big bearing version has a different part number. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear axle shaft.
Not included: wheel studs.








