Overview
The G2 Axle and Gear 95-2011-003 is a big bearing Ford 9 inch rear passenger side axle shaft, 29.31 inches long with 28 splines, for the 1966–1975 Ford Bronco. Its alloy steel is forged and then heat treated beyond OEM specifications.
The 95-2011-003 is intended for the Ford 9 inch rear axle of the Bronco and measures 29.31 inches overall with 28 splines. Wheel studs are not included. It is the big bearing passenger side shaft, so it is not interchangeable with the small bearing shaft; confirm which bearing your axle uses before ordering. The driver side big bearing partner is 95-2011-004. It fits 1966–1972 and 1974–1975 Ford Bronco models plus the 1975 Bronco Sport, and 1973 models are not part of the fit.
Key features
- Passenger side rear axle shaft for the Ford 9 inch axle
- 28 splines
- 29.31 inches overall length
- Big bearing design
- Forged from high grade alloy steel.
Big bearing versus small bearing
Axle bearing style decides which shaft belongs in the housing. Before buying, check the axle tag or cover and compare the bearing style with the shaft you are removing. Mixing big and small bearing parts can leave one side with a bearing that does not seat correctly, so matching the housing matters more than matching the length.
On a Bronco that has seen hard trail use, inspect the old shaft for twisted splines, cracked flanges and a bearing that feels rough or loose. Replace a shaft that shows any of these signs, and look at the axle seal and differential gears while the axle is open. Replacing one side only is common, but a worn partner on the other side can still fail under load.
Wheel studs are not in the box, so buy studs that match the flange before the shaft arrives. After the first few trail runs, re-check the axle nuts for tightness.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2011-003 |
| UPC | 631410105827 |
| Axle manufacturer | Ford |
| Shaft location | Passenger Side |
| Axle position | Rear |
| Axle type | Ford 9 Inches |
| Position | Rear |
| Spline count | 28 Splines |
| Overall length | 29.31 inches |
| Bearing | Big bearing |
| Material | High grade alloy steel, forged |
| Applications noted | 1966-1975 Ford Bronco |
Vehicle fitment
It fits the early Ford Bronco in the years and trims shown below.
- 1966–1972, 1974–1975 Ford Bronco (Base, Custom, Northland, Ranger)
- 1975 Ford Bronco Sport
The list covers 1966–1972 and 1974–1975 plus the 1975 Bronco Sport; 1973 is absent. Small bearing Broncos need a different shaft. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear axle shaft.
Not included: wheel studs.







