Overview
The 97-2033-009 is a driver-side inner axle shaft for the Dana 44 front axle, made for the 1974–1979 Jeep Wagoneer (SJ). It is a chromoly replacement shaft with a 30-spline end and a 5-760X U-joint connection.
The shaft is forged from high-grade alloy steel and heat treated to exceed OEM specifications. It is machined for full circle clips and is the driver-side inner for the Wagoneer application.
Key features
- Driver-side inner shaft
- 30-spline shaft end
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- Forged, heat-treated high-grade alloy steel
Wagoneer front axle notes
A Wagoneer’s front axle works hard on loose trails and steep grades, and the inner shafts take a share of that load through the U-joint and retainer. Before installing, check the joint for play, the retainer for wear, and the splines for damage. Full circle clips need to seat cleanly, so inspect the clip groove on the shaft and the axle tube before final assembly.
Driver-side inner shafts are often replaced with the seal and bearing at the same time, since removing the shaft disturbs both. Clean the axle tube and check for grease leaks that could point to a worn seal. Re-check the joint and retainer after the first few drives, and keep a spare clip on hand for trail work.
- Check the U-joint for play
- Inspect the clip groove before assembly
- Replace the seal during the job
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2033-009 |
| UPC | 631410097207 |
| Axle type | Dana 44 |
| Axle location | Front |
| Shaft position | Driver side, inner |
| Spline count | 30 splines |
| U-joint | Accepts 5-760X |
| Retainer | Machined for full circle clips |
Vehicle fitment
It is made for 1974–1979 Jeep Wagoneer (SJ) models with a Dana 44 front axle. The 1974–1979 range is the one to match before ordering.
The 1980–1990 Wagoneer is a separate application and is covered by other G2 part numbers. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is machined for full circle clips and takes a 5-760X U-joint, so confirm that the joint and retainer on your existing front axle match before installing.
What’s included
One driver-side inner axle shaft.








