Overview
The G2 Axle and Gear Dana 44 JK Chromoly Inner Axle Shaft, part number 97-2051-002, is a 30 spline front inner shaft for the driver side of the Dana 44 axle. It is for use in 2007 up Jeep Wrangler JK models.
G2 says its high-strength axle shafts are forged from high-grade alloy steel and heat treated to exceed OEM specifications. The shaft has a stock overall length, is machined to accept full circle clips and accepts a 5-7166X U-joint.
Key features
- Chromoly inner axle shaft for the Dana 44 JK
- 30 spline design
- Stock overall length
- Driver side inner position, front axle
- Accepts a 5-7166X U-joint
- Machined to accept full circle clips
- Forged from high-grade alloy steel and heat treated to exceed OEM specifications
Driveline service basics
An inner axle shaft transfers torque from the differential to the hub, so wear on its splines or U-joint end shows up as clunks, vibration and lost drive. When the shaft is out, check the spline area and the U-joint bore for wear and look at the axle seal for leaks. Old shafts that were in service for years often carry hidden fatigue that new parts will not reveal.
Front axle work is easier when the vehicle is supported safely, the brake components are protected and the fluid is measured before it is drained. Keep the new shaft clean, lubricate the splines as the job requires, and do not force the shaft into the housing. Check the axle fluid level once the work is finished and the vehicle is back on the ground.
- Inspect the U-joint bore for wear
- Check the axle seal for leaks
- Clean the splines before assembly
- Confirm clips seat fully in the groove
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2051-002 |
| UPC | 631410097399 |
| Product type | Inner axle shaft |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Shaft location | Driver side, inner |
| Axle spline | 30 Splines |
| Material | Chromoly, forged alloy steel |
| Length | Stock overall length |
| U-joint | Accepts 5-7166X |
| Clip design | Machined for full circle clips |
| Use | 2007 up |
| Fit type | Universal |
Vehicle fitment
The shaft is for the Jeep Wrangler JK, the generation covering 2007-2018. It has a stock overall length and is machined for full circle clips.
It is for the front driver side inner position only. It does not fit the passenger side, the rear axle, or other Jeep generations such as the TJ or JL. Confirm fit for your vehicle’s year, model and axle before ordering.
Installation notes
An axle shaft carries drive loads and affects control, so professional installation is the safer route. Support the vehicle on jack stands on level ground, never on a jack alone. Torque fasteners to the correct values and re-check them after the first miles of driving, then have the alignment checked and confirm brake lines, cables and wiring have clearance.
An axle shaft is a driveline component, so use a qualified installer. Fit the matching U-joint and clips, and check the axle fluid level after the work is complete.
What’s included
One driver side inner axle shaft only.
Not included: The 5-7166X U-joint, full circle clips, outer axle shaft and axle fluid.






