Overview
The G2 Axle and Gear 95-2025-201 is a one piece replacement axle shaft for the AMC 20 rear axle in Quadratrac-equipped 1976–1981 Jeep CJ models, made for the driver side. It has 29 splines.
G2 words this shaft for Jeeps with Quadratrac and its one piece axle kit. The company says its shafts are forged from high grade alloy steel and heat treated beyond OEM specifications.
The 95-2025-201 is the driver-side one piece shaft for Quadratrac-equipped CJs, with 29 splines for the AMC 20 axle. It is forged from alloy steel and heat treated beyond OEM specifications. Check that your Jeep has both Quadratrac and the one piece axle kit.
Key features
- One piece design, AMC 20 rear axle
- 29 splines
- Driver-side shaft
- Made for 76-81 CJ Quadratrac models.
- Alloy steel forged and heat treated.
- Used with the one piece axle kit
Quadratrac drivetrain considerations
Quadratrac changes how the Jeep’s driveline is set up, so the drivetrain should be confirmed before any axle part is ordered. Check the transfer case, the driveline and the axle tags against the original build of the vehicle. A shaft meant for a Quadratrac equipped CJ may not suit a standard CJ setup, so confirm the drivetrain first.
Once the drivetrain is confirmed, check the rest of the rear axle. Compare the spline count on the old shaft with the differential gears, and check the seal and bearing for wear. Replace any worn part at the same time, since the axle is easier to service when it is open. Keep the brake lines and parking brake cable clear of the shaft during installation.
- Verify the drivetrain before ordering
- Compare spline counts with the gears
- Inspect the seal and bearing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2025-201 |
| UPC | 631410096705 |
| Product type | Replacement axle shaft |
| Axle type | AMC 20 |
| Axle location | Rear |
| Shaft position | Driver Side |
| Spline count | 29 |
| Stated application | 76-81 Jeep CJ Quadratrac w/One Piece Axle Kit |
Vehicle fitment
It fits the 1976–1981 Jeep CJ5, CJ7 and 1981 Scrambler.
The Scrambler fits 1981 only, and the shaft is for Quadratrac models. Check your year, model and trim against your vehicle before ordering.
Installation notes
- Confirm that your Jeep is a Quadratrac model, as G2 states.
- The 29-spline count has to match your gears.
What’s included
One driver-side one piece axle shaft (95-2025-201).
Not included: the axle kit and wheel studs.







