Overview
The G2 Axle and Gear 95-2013-005 is a rear passenger-side replacement axle shaft for the Ford 8.8 inch axle in the 1997–1999 Ford F-150 and Expedition. It has 31 splines, a 5 on 135mm bolt pattern and 12mm press-fit wheel stud holes.
It is forged from high grade alloy steel and heat treated, with a construction aimed at higher loads from larger tires.
The 95-2013-005 is built for the passenger side of the rear axle. It pairs a 5 on 135mm bolt pattern with 12mm press-fit studs. Compare the bolt pattern and stud size with your hubs and wheels, and confirm that the Ford 8.8 inch axle in your truck uses 31-spline gears.
Key features
- Passenger-side rear shaft for the Ford 8.8 inch axle
- 31 splines
- 5 on 135mm bolt pattern
- 12mm press-fit wheel studs
- Forged alloy steel with heat treatment.
- Wheel studs not included
Stud holes and hub fit
A 12mm press-fit stud is pressed into the hub flange, so the hole diameter and the knurl of the stud must match. Before pressing, check that the flange holes are clean and not stretched from an old stud. A stud that spins or pulls through under load points to a hole problem, and the hub may need replacing rather than the stud being pressed harder.
Wheel bolt pattern matters as much as the axle itself. Measure the stud spacing on your wheels and hubs, and use lug nuts with the seat style your wheels require. Tighten in a star pattern and re-check after the first short drive. If you swap in a different rear axle assembly, verify the spline count and bolt pattern again before reusing these parts.
- Measure the hub flange holes before pressing studs
- Use lug nuts matched to the wheel seat style
- Re-check wheel torque after the first short drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2013-005 |
| UPC | 631410105742 |
| Product type | Replacement axle shaft |
| Axle type | Ford 8.8 inch |
| Axle location | Rear |
| Shaft position | Passenger Side |
| Spline count | 31 |
| Bolt pattern | 5 on 135mm |
| Press-fit wheel stud size | 12mm |
| Wheel studs | Not included |
| Stated application | 1997-1999 Ford F-150 / Expedition passenger side |
Vehicle fitment
It fits the 1997–1999 Ford Expedition and the 1997–1999 Ford F-150.
The dates stop at 1999, so earlier trucks such as the 1987–1996 F-150 and Bronco use a different G2 shaft. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- The 12mm press-fit studs have to be installed by the owner, since they do not come on the shaft.
- Match the 5 on 135mm bolt pattern of your wheels and hubs to this shaft before it goes in.
What’s included
One passenger-side rear axle shaft (95-2013-005).
Not included: wheel studs for the 95-2013-005.






