Overview
The G2 Axle and Gear 2-2011-620 is a 6.20 ratio ring and pinion set for the rear Ford 9 Inch axle. The ring gear and drive pinion inside the differential set the final drive ratio: a 6.20 ratio means the pinion turns 6.20 times for each full turn of the ring gear, which multiplies engine torque at the wheels.
The Performance Ring and Pinion line is built for oversized tires and high-performance engines, using current manufacturing technology and materials. The set is matched by axle type rather than by a vehicle model, so the 9 Inch housing on your vehicle decides fit before you buy.
Key features
- 6.20 gear ratio for the Ford 9 Inch rear axle
- Ring gear and pinion supplied as one matched set
- It is designed for oversized tires and high-performance engines.
- It is made with current manufacturing technology and materials.
- Rear axle location
Break-in and first drive
A new ring and pinion needs a gentle start. The tooth faces are still polishing against each other during the first miles of driving, so light throttle and moderate speeds help them seat evenly. Hard launches, sustained heavy towing and high rpm runs are better saved until the gears have run in and the carrier has settled.
Gear oil matters as much as the gears. Use the gear oil grade and friction additive your axle requires, and fill to the correct level once the set is installed and the carrier is preloaded. Many rebuilders change the oil again after the initial break-in period to remove wear material picked up while the teeth mated. Keep an eye on temperature and noise during the first drives.
- Avoid hard launches until the teeth have seated
- Check the gear oil level after the first drives
- Listen for a steady whine rather than clunking
- Keep a record of the setup measurements for later service
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-620 |
| UPC | 631410110210 |
| Axle type | Ford 9 Inches |
| Axle location | Rear |
| Gear ratio | 6.20 |
| Axle manufacturer | Ford |
Vehicle fitment
It is matched to the Ford 9 Inch rear axle, so check the housing and carrier on your vehicle against that axle type rather than a model year. A different Ford or non-9 Inch axle will not match this set. Check your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting tooth contact, backlash and carrier preload on a 6.20 set takes specialty tools, so a gear shop is the usual route. Plan on a break-in period as the new teeth seat, and keep the first hard runs moderate.
What’s included
One ring and pinion set (ring gear and drive pinion) for the Ford 9 Inch axle, sold under part number 2-2011-620.
Not included: Pinion bearings, shims and carrier installation parts are sold separately, so source them to match your 9 Inch carrier.
















