Overview
The G2 Axle and Gear 2-2034-538RX is a 5.38 ratio thick front reverse ring and pinion for the Dana 60 front axle. It is made for carriers at or below a 4.10 ratio, so check the carrier ratio before installing.
G2 describes its ring and pinion sets as engineered for oversized tires and high performance engines. This thick reverse version uses computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- Thick front reverse 5.38 ring and pinion
- Dana 60 front axle
- For use with 4.10 and down carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Thick gears and tooth load
A reverse front axle places the pinion on the opposite side of the carrier from a standard layout, which changes how the gear set sits in the housing and how the drive shaft angles. Thick reverse gears carry a deeper ring gear body to handle more load, and that extra section is often paired with heavier front axle work when the rest of the front end is upgraded.
Front axles carry steering and brake parts close to the carrier, so mounting and clearance should be checked after the gears are set. A higher numerical ratio such as this one puts more torque through the teeth at low speed, which is why the pinion bearings, carrier bearings and bearing preload should be inspected at the same time as the gears.
- Inspect the carrier bearings for play before fitting
- Check ring gear runout on the carrier
- Look for chipped teeth or uneven wear after the first runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-538RX |
| UPC | 631410094244 |
| Gear ratio | 5.38 |
| Axle location | Front |
| Axle type | Dana 60 |
| Popular axle manufacturer | Dana |
| Carrier requirement | 4.10 and down |
| Version | Thick, front reverse |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
The 5.38 set is built for the Dana 60 at a 5.38 ratio. Confirm the axle position and carrier before ordering.
It is built for the front Dana 60 axle. Match your vehicle’s year, model and trim before ordering.
Installation notes
With a 5.38 ratio on a thick reverse gear, pinion depth, backlash and bearing preload should be set by a driveline shop before the axle is put into service.
What’s included
A matched thick front reverse ring and pinion for the Dana 60 front axle.
















