Overview
The G2 Axle and Gear 2-2032-373 is a 3.73 ratio ring and pinion for the Dana 30 standard front axle. It is made for 3.73 and up carriers, so match the carrier to this ratio before fitting the gears.
A 3.73 ratio is numerically lower than 4.10 or 4.88 gears, which gives less torque multiplication at the wheels. The gears are designed for oversized tires and high performance engines, and are made from computer heat treated 8620 steel with double shot peened surfaces.
Key features
- Dana 30 standard front ring and pinion
- 3.73 ratio for 3.73 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Front axle gear basics
The front axle on a four-wheel drive carries steering and drive loads together, so the ring and pinion works under constant changes in angle and torque. A numerically lower ratio like this one suits steady road speeds, and the trade-off is weaker pulling at low speed. The carrier, bearings and axle housing all need to match the ratio before the gears go in.
Maintenance is simple but easy to skip. Check the axle fluid for metal flakes at each service, and inspect the pinion seal for leaks. When the carrier is out for gear work, the pinion bearings and carrier bearings should be checked for roughness or play and replaced if needed.
- Check the carrier rating before fitting
- Inspect the pinion seal for leaks at service
- Replace rough or loose bearings while the carrier is out
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2032-373 |
| UPC | 631410105308 |
| Gear ratio | 3.73 |
| Axle location | Front |
| Axle type | Dana 30 standard |
| Popular axle manufacturer | Dana |
| Carrier requirement | 3.73 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Dana 30 standard at a 3.73 ratio. Confirm the axle type and carrier before ordering.
A Dana 30 reverse gear set is a different part and is not covered by this 3.73 standard set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth and backlash on the 3.73 gears with a driveline shop, then run the axle through a break-in period before full use.
What’s included
A matched ring and pinion for the Dana 30 standard front axle.
















