Overview
The G2 Axle and Gear 2-2080-411 is a 4.11 ratio ring and pinion for the rear Dana 80 axle. The pinion turns 4.11 times for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels and is suited to larger tires.
The Performance Ring and Pinion line is built for oversized tires and high-performance engines, using current materials and manufacturing methods. Measure the housing and carrier on your vehicle before purchase to confirm the match.
Key features
- 4.11 gear ratio for the Dana 80 rear axle
- Rear axle location
- Ring gear and pinion supplied as one matched set
- Designed for oversized tires and high-performance engines.
- Made with current materials and manufacturing methods.
Setup and carrier checks
A 4.11 ratio multiplies torque at the wheels, which helps when pulling loads or climbing with larger tires. The trade-off is higher engine speed at highway cruising and a bit more noise. Decide on the ratio by how the vehicle is driven most of the time, and confirm the Dana 80 housing matches before buying.
Changing gears is a chance to check the rest of the carrier. Pinion seals, carrier bearings and the pinion crush sleeve are commonly replaced together. A limited-slip or locker should be inspected for wear before the new ring gear goes in, since its clutch surfaces wear alongside the gears.
- Check carrier bearing preload with a dial indicator
- Replace the pinion crush sleeve during reassembly
- Inspect the locker clutch surfaces for wear
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2080-411 |
| UPC | 631410105261 |
| Axle type | Dana 80 |
| Axle location | Rear |
| Gear ratio | 4.11 |
| Axle manufacturer | Dana |
Vehicle fitment
Confirm the rear Dana 80 housing and its carrier on your vehicle before ordering. Match the ring gear and carrier to this set.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tooth contact and backlash on a Dana 80 set need measured setup, so a gear shop with the right tools is the usual installer. Allow a break-in period before heavy loads.
What’s included
One 4.11 ring and pinion set for the rear Dana 80 axle, part number 2-2080-411.
Not included: Carrier bearings, shims and carrier hardware are not part of this 4.11 Dana 80 set. Check your carrier’s requirements before installing it.
















