Overview
The G2 Axle and Gear 2-2032-410 is a 4.10 ratio ring and pinion for the Dana 30 standard axle, in the front and rear locations G2 lists. It is built for 3.73 and up carriers, so match the carrier to this ratio class before fitting.
G2 describes its performance sets as made for oversized tires and high performance engines. This 4.10 Dana 30 standard set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 4.10 ratio Dana 30 standard ring and pinion
- Fits front and rear locations.
- For use with 3.73 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Front axle upgrade planning
Axle gearing is a balance between low-speed pull and highway engine speed. A 4.10 set gives more pulling force at low speed, which helps with steep climbs and heavier tires, but engine speed rises at highway cruising.
Ring and pinion sets are normally replaced as a matched pair, and the pinion depth, backlash and bearing preload need to be set together. Carrier bearings, pinion seal and axle bearings are often inspected at the same time, since the axle is already open. Worn parts left in place can shorten the life of new gears.
Before buying, check the axle position and the carrier ratio class, since a gear set for one position or carrier may not suit another. Reverse gear sets are separate parts and need their own check.
- Check the carrier ratio class before buying
- Inspect bearings and seals during the swap
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2032-410 |
| UPC | 631410093889 |
| Gear ratio | 4.10 |
| Axle location | Front and rear |
| Axle type | Dana 30 standard |
| Popular axle manufacturer | Dana |
| Carrier requirement | 3.73 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Dana 30 standard axle at a 4.10 ratio. Confirm the axle position and carrier before ordering.
A Dana 30 reverse gear set is a different part and is not covered by this standard set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth and backlash on the 4.10 Dana 30 gears with a driveline shop, then run the axle through a break-in period.
What’s included
A matched ring and pinion for the Dana 30 standard axle.















