Overview
The G2 Axle and Gear 35-2080 is a master ring and pinion installation kit with bearings for the Dana 80 axle.
The 35-2080 contains the parts needed to install a ring and pinion properly, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. Some of these parts are hard to find and rarely stocked by auto parts stores. It is not for use in 1999 up Ford Super Duty duallies. The ring and pinion gear set itself is not included.
Key features
- Master kit with bearings for the Dana 80 axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
- Not for use in 1999 up Ford Super Duty dually
Dana 80 setup notes
The Dana 80 is a heavy axle, and its gears are often used under towing and hauling loads. Because of that, bearing preload and pinion depth need to be right from the start. Before assembly, clean the housing, inspect the bearing bores and make sure the carrier is free of nicks that could affect the new bearings.
Setup is the most important step. Use gear marking compound to check tooth contact after each shim change, and recheck the pattern under light load. A quiet, even pattern is the goal. Keep the gear oil clean and inspect the fluid after the first trips, since small metal particles can point to a problem in the new gears or bearings.
- Inspect bearing bores before assembly
- Check tooth contact after each shim change
- Watch for metal in the gear oil after early use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2080 |
| UPC | 631410096088 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | Dana 80 |
| Popular axle manufacturer | Dana |
| Kit type | Master kit with bearings |
| Listing condition | Not for use in 1999 up Ford Super Duty dually |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2080 is identified by axle rather than by vehicle: it is made for the Dana 80 axle. It is not for use in 1999 up Ford Super Duty duallies.
It is not made for other axle designs or sizes, so confirm your housing is a Dana 80 before buying.
Installation notes
A master kit such as the 35-2080 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2080 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2080: ring and pinion gear set.











