Overview
The G2 Dana 70 4.10 Ratio Ring and Pinion (part number 2-2035-410) is a rear gear set for the Dana 70 axle with a 4.10 ratio. The axle type is Dana 70, the location is rear, and the axle is made by Dana.
The ring and pinion is the final drive gear pair in the axle, and its ratio sets how many times the driveshaft turns for each turn of the wheels. G2 says its sets are built for oversized tires and high-performance engines and uses current materials in manufacturing. This 4.10 set changes the ratio of a Dana 70 rear axle and should be matched to the rest of the driveline.
Key features
- Gear set for the rear Dana 70 axle
- 4.10 gear ratio
- Ring and pinion supplied as a set
- Built for oversized tires and high-performance engines, with current materials in manufacturing
Gear swaps on a Dana 70
The Dana 70 rear axle is a heavy unit, and its ring and pinion sets the final drive ratio for the rear wheels. A 4.10 set changes how the driveline turns the wheels, so it should be picked with the transmission, tire size and engine in mind. Rear axle work is easier when the housing cover, the carrier and the axle shafts are in good shape.
Pinion bearings, shims and carrier hardware usually come off during a gear swap, and they are best replaced along with the gears. Gear mesh and pinion preload need to be set correctly, so a shop with setup tools is the right place for the job. Check the axle housing for cracks or leaks when the cover is off.
- Replace pinion and carrier bearings during the swap
- Check shims and preload with the new set
- Inspect the axle housing and seals when the cover is off
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2035-410 |
| UPC | 631410094275 |
| Axle location | Rear |
| Axle type | Dana 70 |
| Axle manufacturer | Dana |
| Gear ratio | 4.10 |
| Fitment type | Universal fit (per G2) |
Vehicle fitment
It is made for the rear Dana 70 axle. Match the axle housing to your vehicle before fitting, and confirm the year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing gear ratios is shop work: the mesh and pinion preload have to be set correctly, and the new gears should be run in before the axle sees heavy loads.
What’s included
The set is the ring and pinion only. Pinion bearings, shims and carrier hardware need to be sourced separately.















