Overview
The G2 Axle and Gear 2-2034-513 is a 5.13 ratio ring and pinion for the Dana 60 axle. Its ratio means the pinion turns 5.13 times for every turn of the ring gear, a steep setting that favors acceleration and low-speed pulling.
The Performance line is made for oversized tires and high-performance engines, with current materials. This set fits the Dana 60 in front or rear positions. Verify the housing type and location on your vehicle before ordering.
Key features
- 5.13 gear ratio for the Dana 60 axle
- Fits front and rear axle locations.
- Ring gear and pinion sold as a matched pair
- Designed for oversized tires and high-performance engines.
- Made with current technology and materials.
Choosing the right setup
A 5.13 ratio is one of the steeper gear choices for a Dana 60, so it changes how the drivetrain feels at every speed. Stronger pulling from a stop comes with higher engine revs on the highway, and the change is most noticeable with heavier tires and a loaded bed. Think about daily driving before committing, because a gear this steep can feel busy on long highway runs.
Pick the ratio together with tire diameter and transmission gearing, since those three decide the final speed and engine rpm. If the axle is being changed for a different tire size, recheck the carrier, pinion depth and gear oil level after installation. Expect the old gears to show wear signs such as chipped teeth or a whine under load, which is a good reason to inspect the carrier at the same time.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-513 |
| UPC | 631410094213 |
| Axle type | Dana 60 |
| Axle location | Front or rear |
| Gear ratio | 5.13 |
| Axle manufacturer | Dana |
Vehicle fitment
This 5.13 set is matched to the Dana 60 axle in front or rear positions. Confirm the housing and carrier on your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.13 set calls for measured tooth contact and carrier preload, so a gear shop is the usual installer. A break-in run is needed before heavy use.
What’s included
One 5.13 ring and pinion set for the Dana 60 axle, part number 2-2034-513.
Not included: Carrier bearings, shims and installation hardware are not part of this set.















