Overview
The G2 Axle and Gear 2-2021-513 is a 5.13 ratio ring and pinion for GM 10 Bolt 8.5 inch axles. The pinion turns 5.13 times for each ring gear revolution, a numerically high ratio that favors acceleration and low-speed pulling force over highway rpm, and that trade-off is the main reason to pick it.
The set fits the 8.5 inch and 8.6 inch 10 Bolt ring gears in both front and rear positions. It targets oversized tires and high-performance engines. Vehicle models and years are not identified, so measure the ring gear and confirm the axle location before ordering.
Key features
- 5.13 gear ratio for GM 10 Bolt 8.5 inch axles
- Fits 8.5 inch and 8.6 inch ring gear housings.
- Fits front or rear axle locations.
- Ring gear and pinion sold as one matched set
- Made for oversized tires and high-performance engines.
Before you buy
A numerically high ratio like 5.13 changes how the axle feels day to day. The engine works harder at highway speed, so cruising rpm runs higher, but low-speed launches and loaded starts get stronger pull. Think about how the truck is used most. Daily driving with stock tires may feel busier, while trail work and towing usually benefit from the extra pull. Gear swaps are done with the axle out, so plan the labor and time together with the parts.
Gears seldom go in alone. Pinion bearings, carrier bearings and shims are often replaced during a swap, and a worn carrier can make new teeth wear quickly. Inspect the carrier and axle bearings while the housing is open. Keep a written record of the pinion setup so future service goes faster and the mesh is easier to restore.
- Measure the ring gear before ordering
- Plan labor time with the parts
- Renew bearings that show roughness
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2021-513 |
| UPC | 631410093575 |
| Axle type | GM 10 Bolt, 8.5 inch or 8.6 inch ring gear |
| Axle location | Front or rear |
| Gear ratio | 5.13 |
| Axle manufacturer | GM |
Vehicle fitment
Fitment is not tied to specific vehicles. The 5.13 set fits GM 10 Bolt 8.5 inch and 8.6 inch axles, so check the ring gear size and whether your housing is a front or rear unit. Any other axle family needs its own fit check before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.13 set needs correct tooth contact and carrier preload, and gear shops usually handle the setup. Expect a break-in period, and keep early loads light while the teeth settle.
What’s included
One 5.13 ring and pinion set for GM 10 Bolt 8.5 inch axles, part number 2-2021-513.
Not included: Carrier bearings, shims and installation hardware are outside this kit and may need separate purchase.
















