Overview
The G2 Dana 44 4.89 ratio ring and pinion, part 2-2033-489, is a gear set for Dana 44 axles at a 4.89 ratio. It is made for use with a 3.91 and up carrier and is built from computer heat treated 8620 steel.
The gears are double shot peened and double lapped, and they are made to O.E. specifications. The set is built for oversized tires and high performance engines.
Key features
- 4.89 gear ratio
- Designed for Dana 44 axles
- For use with a 3.91 and up carrier
- Computer heat treated 8620 steel
- Double shot peened and double lapped
- Made to O.E. specifications
- 10 year warranty
Gearing and tire size
A 4.89 ratio is a steep, low-speed gear. The engine turns more times for each wheel turn, which gives strong pulling force for big tires, rock crawling and loaded towing, but it also raises engine speed at highway pace. Heavier loads and steep grades put more stress on the teeth, so keep the setup accurate.
Gearing is a system choice. Tire diameter, transmission gearing and the transfer case ratio all affect how the vehicle performs, so compare the total result rather than the ratio alone. Changing tire size later usually calls for revisiting gearing.
Dana 44 axles are often rebuilt in the same job as a brake or bearing service, so inspect the axle shafts, seals and pinion yoke while the housing is open. Keep the new gears clean and use the correct oil at the correct level.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2033-489 |
| UPC | 631410094046 |
| Axle type | Dana 44 |
| Gear ratio | 4.89 |
| Carrier requirement | 3.91 and up |
| Gear material | Computer heat treated 8620 steel |
| Finish process | Double shot peened, double lapped |
| Axle location | Front and rear |
| Warranty | 10 years. |
Vehicle fitment
It fits Dana 44 axles with a 3.91 and up carrier. The axle type and carrier size decide whether this set matches your vehicle, so check both before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A ring and pinion set needs professional setup. Pinion depth, backlash and bearing preload must be set correctly, and the gears need a break-in period before hard use. Because the set is built for oversized tires, match the setup to your tire size and gearing.
What’s included
One ring and pinion gear set, ratio 4.89, for Dana 44 axles.














